Ok, found and fixed the issue I just discovered, so here is another quick build tip, pull apart your servo saver, take the cup side of the cam, and file/sand down the cup a little bit, test fit and after removing no more than a mm or so, the cams can now fully touch/seat properly, and no more play.

Plastic mold glitch?, the cup sits just a shade tall, so the oposing cams don't fully seat/touch, result is a few mm of steering play in the servo saver, file down that cup a mm or so and it's slop/play free.

So the question I have to ask is, was it effecting my turn in?.



I was giving it a month before someone tried to brace it themselves, you beat the bet I had with myself.