Hi there,
I finished assembling my new trf417 and I have few questions:
1. Regarding the steering, even though I adjusted the adjustment rod to the exact same measurements, I can still see that the right wheel is a little bit more to the right than the left wheel. Has anyone had the same issue and had to make one rod longer to fix it? Also, even though the servo was exactly at neutral at the time I installed the handle but i still had to trim a lot for the wheels to point straight, and again that was following the manual's measurements. Is that normal?
2. I noticed that the rear wheels wiggle a little bit, I am not sure if it's the wheel itself that is not a perfect disk or something else. Should I worry about?
3. Finally, I had to install around 3 0.1mm shims on the rear wheels because the axis was playing a it, I was able to wiggle it in and out without the shims. Should I keep them?
Sorry my questions are basic, but I am relatively new to this hobby.