Originally Posted by
tcdrvr2
I"m trying to duplicate a setup posted on the RSD thread and it calls for the steering Bellcrank to be set at 7C and the link to be set to 1B, however when I try to do this the top of the servo saver hits the bulkhead and top deck. So am I missing something or is this not possible. It is not listed in the manual but with the problems that book has, it's possible something was left out. Thanks for the help in advance.
When using the forward bellcrank position you need to clearance the top deck and the boss on the bellcrank to attain full throw. Unfortunately it's just a matter of trial and error using something like an xacto or a fine cutting bit with a dremel to remove as little material as possible.
I would recommend on focusing on the bellcrank boss and once you've taken that down then make any remaining clearances on the underside of the top deck right next to the bulkhead.
Hope this helps!