R/C Tech Forums - View Single Post - How many here running large scale?
View Single Post
Old 09-21-2011, 11:36 AM
  #18  
46u
Tech Regular
iTrader: (4)
 
46u's Avatar
 
Join Date: Oct 2006
Location: Macon, Georgia
Posts: 334
Trader Rating: 4 (100%+)
Default

I read a lot of good things about Dog Pile Racing. Do you have one of his long rod motors or standard length rod motors. I do not have any real hot motors. I do have a race ported 30.5 that I built with one of OBR kit and a GP290 I built with one of ESP race ported cylinders and two stock motors all 2 bolt.

I just bought a set of new CY 4 bolt cases I hope to put one of OBR prostock 30.5 kits in some day. Reason I went with the CY 4 bolt case is I got them for $28 shipped. I will not be running the CY bearings will be getting better bearings.

OBR new Pro Stock line of motors are taking place of the race ported line and are putting out 1/2 to 3/4 more HP then their race ported.

Here is a couple pictures of my 5b SS and a list of up grades.
Team Associated throttle brake
DS1015 servo
201oz
0.108 speed

Turtle Racing
Complete Clutch System (Orange)

Turtle Racing
HD Tranny Plate (Orange)

Threshold
Shock Umbrella Seals with installation tool

Turtle Racing
Heavy Duty Front Chassis Brace

HPI
Front tire molded foams

washers for e clip conversion

Fast Eddie
Wheel Shim Kit

Scorpion Chassis Brace Satin

Pro-Match 6v 4200mAh Hump Receiver Battery

FF Front/Side Windows Smoked

Killer RC kill switch

Outerwares pull starter cover

PhatDad Fan Cover Saver

Nomadio RX

Quick Release Roll Cage Tubes

Hostile Mini MX Tire Soft

Lauterbacher 4 shoe adjustable off road clutch

Outlaw RC upper rear turnbuckles

HPI 87454 Engine mount brace set CF

Team Phat Dad
Front stainless steering turnbuckle set

87549 - HPI HD front aluminum shock mount

CPI big bore Tuned Pipe

Full Force CF brake disc and alloy pads

HPI 87572 alloy heavy duty brake mount

CraftWerks-RC Billet Spur Gear Carrier

Team FastEddy Complete Bearing kit

HPI Heavy Duty 20T Drive Gear 86487

HPI Heavy-Duty Idle Gear 30 Tooth 86485

HPI Heavy Duty Differential Gear 48T:Baja 85481

Skunkworks Titanium Lay shaft

Multiplex Rhino Digi 4 steering servo
On 6 volts
Torque 354 in/oz
Holding power 318 in/oz
Speed 0.10 sec at 60 degree

PA Racing Servo Bracket

TGN CF tank brace

Outerwear air filter cover red

Phat Dad RC Cross-Over Dog bones

Chacal-RC Axle Cup Rings

HPI 187444 CF Rear Chassis

Outerwears Crankcase/Flywheel Cover

Right now running my race ported motor with OBR 30.5 kit.

It is not as pretty as in these pictures now. LOL

46u is offline