R/C Tech Forums - View Single Post - MTX 5
Thread: MTX 5
View Single Post
Old 09-21-2011 | 03:56 AM
  #927  
chookgb's Avatar
chookgb
Tech Fanatic
iTrader: (29)
 
Joined: Jun 2002
Posts: 994
From: newcastle
Default
Originally Posted by TomB
also i have a question about the clutch setup.

i noticed that when i built the clutch as per instructions the bell would hit the shoe quite heavily when i tried to spin the bell.

is this ok?

or should i shim the bell out until it spins freely without hitting the shoe?....

and then shim it for end play?
another strange post, may i suggest you re-read the instructions, as the clutch i built as per the instructions spins freely, although i reduced my end float from .5 to .3
chookgb is offline  
Reply