Originally Posted by losi8lunie

Hi guys

I've swapped to an ezrun 60a 5.5t combo for my buggy and so far been really impressed with the performance - way faster than my old setup and a 1/3rd of the cost. However I've a couple of questions regarding the motor and the programming box

I can only get to option 10 on the LED - I want option 11 so I can reverse the motor so I can run in my mid motor car, any ideas as to how?

On the motor I want to remove the soldered in bullet connectors so I can put them on the opposite side as it rubs my bodyshell - I've tried to desolder them but can't get them off, again any ideas or is it not possible