Originally Posted by
Mazda614
Anyone noticed that when the throttle / brake is applied that the engine /chassis flex back and forth. Is this supposed to happen or I have set something up incorrectly. Routing the battery leads is a pain everything is so tight, but the servo tray is a great idea very easy to remove. Still haven't worked out how to get to the front belt easily
like Gregory said, you have too much throttle end point and too much brake end point.
i spaced my throttle servo further out with some spacers so as to have a small amount of room between the tank and the throttle servo, i then routed the wires between this gap.
The manual says to place the wires on top of the throttle servo, but if i did this the tank would not sit properly.
regarding the chassis plate, i found mine has an upwards bow in the centre. it's about 1 or 1.5mm higher in the middle when laid on blocks.
This was noted before building so it isn't a tweak from the build.