Originally Posted by
BSchorr
A friend/regional viper driver gave me these settings to start with...
Brake strength - 80%
Brake PWM freq - 8000HZ
Brake curve - linear
Neutral drag brake - 10%
Throttle PWM freq - 9600Hz
Throttle punch - 75% - 90% depending on traction
Throttle curve - -1Expo
Deadband - middle
Stock Blinky mode
Motor temp cuttoff - Disabled
ESC protection - 200 degrees
Holeshot mode - off
Anyone think of anything else?
This is what we at Viper recommend.
VTX10R-Profile#2
Brake strength 80%
Brake PWM freq 8000HZ
Brake curve linear
Neutral drag brake 10%
Throttle PWM freq 9600Hz
Throttle punch 15%-20%
Throttle curve linear
Deadband middle
no timing- default
no motor protection
esc protection 240 degrees
Originally Posted by
X God
How are these 4 pole motors compared to the VSE motor, My question is would in work in 1/8 th scale with a 10r
No, it's a 1/10th scale system, it's benchmarked in the SCTe so unless you are rolling a 810, I'm going to say no.
Originally Posted by
DoucheMaloosh
Yesterday was my first day with my Viper R/C VTX10 ESC & VST 7.5 motor. I love it.
I got 2nd in mod 2wd.
Saw the results!! You had a very short time for setup last night and did very well. Nice work!
