R/C Tech Forums - View Single Post - Serpent S411
Thread: Serpent S411
View Single Post
Old 09-07-2011, 06:13 PM
  #1078  
Dragonfire
Tech Champion
iTrader: (1)
 
Join Date: Feb 2003
Location: Sydney, Australia
Posts: 5,310
Trader Rating: 1 (100%+)
Default
Originally Posted by Besercoe
Patto, a couple of questions

What is the hole size of serpent pistons?
the lower block spacing on the front, is it 0.5mm FF and 3.0mm RF block?

You also have a very large split in springs, 13lb to 19.5lb seems huge, have you tried closer spring rates?
Brad the 411 uses a flipped block for the rear of the front arms. With that in mind 3mm on a flipped block is.equal to 0mm on a normally orintated block.
Dragonfire is offline  
Reply