got hooked up by Matt from Nitro-North yet again went thru my gx-II, replaced both bearings, all needle o-rings, AND a new clutch setup....took my clutch bell off to inspect the shoes for wear after 1/2 gallon (in an X-RAY XTB) and what i saw was phenominal!!!! very VERY little evidence of wear at all, no discoloration, and the springs were just what I was looking for as far as over all feel!!!




.....now if only GO would just do and exclusive deal with S-Works (that's where I think the gx 3 and 7 port motors went).....