My shocks rub on the cartridges, and I don't care at all. I'd rather have them rubbing than dremeling out the cartridge.

OR even better, I'd rather buy aftermarket 1/8 springs of similar stiffness but made for 14mm or bigger bigbores and adapt them to the needed length.


@BLV: I don't have my setup sheet, but right now I'm rather happy with my setup.

Running with stockers, but with AKA Rebars/GridIrons side bit should increase a fair bit. The rear end is a bit loose under gentle throttle, but very controllable and predictable on the sliding. Will get Proline Calibers in short, will report with them.

Full stock setup, 4oz ballast in front of the ESC (right at the front of the middle chassis), rear body mounts one notch away from the maximum height, front body mounts at the very middle (increases downforce and helps with grip at high speeds/loose corners). 5000mAh 2S stick pack, 26mm high (it's one of the first hardcase high end LiPo packs made, IP 5000mAh 25C), rather heavy. Probably in the same weights as a current 5600mAh Reedy stick.

---


Screw it, I'm making the setup sheet.

There ya go: