Originally Posted by
MRGierut013
I didn't know a high response mode would damage an analog servo, thanks for the tip. I'll have to check my radio when I get home from work.
The EPA settings are fine, I took my time setting up the trims and EPAs for the truck before I even started it for the first time.
The throttle servo that was giving me trouble was analog.
Why analog servo can't use in high response mode?
it cause of...
analog servo use normal servo standard signal.
the normal servo signal have refresh rate about 14-20 millisecond.
while, the refresh rate of high response mode only 4-6 millisecond.
So, when use analog servo in high response mode, it will have error occur.
Why digital servo can use both normal and high response mode?
it cause of...
digital servo firmware, support both normal and high response signal.