Originally Posted by
MRGierut013
Ok, I think I got it.
The glitches occur with or without the engine running, with or without the failsafe connected, and on channels 1 and 2 if I switch the wires on the receiver.
With that said, it's not radio interference, not a faulty failsafe, and not the reciever. It's the servo. It freaks out every time it gets power, and ignores all incoming signals, whether it be from a failsafe or a radio command.
i think that you got the right way to finding the cause.
one comment, before you replace with new servo.
you should check your servo arm about relation of throttle and break setting. and your Transmitter TH EPA setting.
wrong setting can damage servo.
and don't forget about ...
we must don't use analog servo with any High-Response mode.
it can damage servo too.
Transmitter setting, servo response.
Servo Normal mode : use for analog and digital servo
Servo High Response mode : use for digital servo ONLY!
So, you shound know about your FUTABA throttle servo.
it's analog or digital.