R/C Tech Forums - View Single Post - Servo Voltage
Thread: Servo Voltage
View Single Post
Old 08-28-2011 | 08:36 AM
  #2  
AreCee
Tech Elite
iTrader: (1)
 
Joined: May 2003
Posts: 4,337
From: Northern & Central Illinois
Default
Originally Posted by Lapster v2
Hey guys,

I have a Mugen MBX6 Eco with a Tekin RX8 and T8 motor. Im running a 4s lipo pack with a spektrum receiver. I been looking at servos and see a different set of specs for 4.8v, 6.0v, and in some cases 7.4v. What specs should I be looking at and if there is a way, can I run 6.0v if I am not already?

Steve
Your RX8 supplies 6V to the receiver/servo. So you do have what you want.

If you want to feed 7.4V to the servo you will need to bypass the Tekin's internal BEC and use a Castle BEC set by a Castlelink to 7.4 volts.
AreCee is offline  
Reply