I recently bought an EZRUN 35A / 9T 4300 brushless combo. Im waiting on a Spur for my EXT2 so I put it in my buddys Stampede to c what it would do. After a few min of running it shut down, and I assumed it was the overheat kickin in. After a few min i reconnected the batt n turned on the ESC. Right away the diode or resistor (the black thing on top of the heat sync) got hot n one of the legs the connects it to the board burnt in half. I looked inside the esc n nothing else seems to b burnt or out of place. Does anyone know what in the world could have caused this. Im running a 3s 11.1v lipo, but ive seen that done lots of times w/o hurting anything.