Originally Posted by
bertrandsv87
The losi lcd's (part#losa3344) are about $35 a pair on the web (Amainhobbies...etc...), but they fit the tc4 ,I don't know about the tc3 ! If your tc3 uses cvd bones #3888 or #31034 , with Ae axles #3886 , then the losi lcd's will fit nicely ......
Yep 3888 and 3886, sorry for saying but I found Amain a little expensive in comparison of others found around, I am sure the service is good as many of you buy there, but i have to look at postage cost here also, and it is cheaper from HK than US.
I gather that you are using the same bearings, are the nuts the same as TC3 or are they metric? Unlikely thought my Losi were Imperial too.
I am actually looking for a solution to put the TC3 on metric size screws, it will be easier for the tools as TC6 is metric too.