R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 08-22-2011 | 05:12 PM
  #6730  
rednck21's Avatar
rednck21
Tech Master
iTrader: (106)
 
Joined: Dec 2009
Posts: 1,797
From: Kennesaw, Ga
Default
Originally Posted by Cameron Kellogg
DE does not make a special wheel yet. I was just looking at the wheels that are made now to see if one is already that off-set. Turns out this is something special that Jconcepts made for Mayfield,BK, and the AE/Jconcepts team for the SC10. Now that they won again we all need to have this wheel off-set right?

If I could find a set to run I would like to test run them to see if its noticeable better. Lower CG is something we all have been chatting about so it might help. For right now I will test the DE xxxt-sc wheel and see if I can tell a difference.


i think im going to throw a 4mm washer or two on top of each hex to test the wider stance. not the best solution, but i do have serrated nuts....
rednck21 is offline  
Reply