R/C Tech Forums - View Single Post - Sh .28 won't run right.
Thread: Sh .28 won't run right.
View Single Post
Old 08-19-2011 | 07:20 AM
  #7  
inferno13
Suspended
iTrader: (202)
 
Joined: Dec 2009
Posts: 7,916
From: northern michigan
Default
Originally Posted by Hurricanextr
Well same thing today. Cleaned the carb, check lines, reset to stock and to what user here said. Still it ran, I got 10' and shut off on idle, Won't start anymore. If I wait 10 mins and try again it'll start. Even when I advance my trim it may start for a second and shut off. Got my fingers tore to pieces on the darn pull cord. This is really getting on my nerves.

When it first started today there was fuel coming out the pipe, I could see it spitting so I leaned it out a little. When give it throttle it had puff of smoke and nice trail behind. Went to turn around and just shut off and no start.

I also adjusted my idle too, about 1.5 mm.

HELP!!
Sounds like your getting to much fuel, set needles at factory settings and then turn the HIGH SPEED NEEDLE IN 3 TO 4 HOURS. and turn your LOW SPEED IN 1/2 TURN, you may have also fouled out your plug. change plug and try that, also make sure head bolts are tight
inferno13 is offline  
Reply