Originally posted by Pyramid
Does it mean you do not have the failsafe mode/PCM on? Because I believe it wont glitch, it will stay at where you programmed them. Or is it not?
This is with failsafe on on the 3PK.
Somehow the 3PK works like this. After resting the Rx/Tx for about a minute or more, I could plug the Rx to the batteries and it will not even move. Once I switch on the Tx, the servos are controlled normally. If I then switch off the Tx first before the Rx, the servos will be in fail safe mode.
If others are on the same frequency, the servos will glitch and behave weird when I just plug the batteries to the Rx without switching on the Tx. That's when I know somebody is using the same frequency as I am.