R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 08-18-2011 | 03:34 PM
  #13913  
buglite62
Tech Apprentice
iTrader: (2)
 
Joined: May 2008
Posts: 91
Default
Originally Posted by unicorn87
Hello!

I am new here but in need of help..

I bought used Go Engine R2100 M00HSG
hobbypartz.com/le21nirccare.html

But i did not get manual/info about factory needle settings.
So if anyone have this motor or know factory needle settings could you help me out ?

Mihael
I think the majority of the Go's you start with both needles flush. With it being used maybe start with each needle in an hour and see how it runs? This is a big stab in the dark, does it run at all where the needles are at now?
buglite62 is offline  
Reply