Originally Posted by
racene1
I am having some trouble. I just installed a 10r into my sc104x4 with an LRP 5.5 540 with a 13mm shaft (yes you read that correctly 540) i am running 12/62 on the gearing. My motor temps are around 125 -130 for the 3 mins i am able to run it but my esc temps get up to 175-200 especially the 2 resistors and the wire/post connections. I am running no punch, highest pwm on the throttle and the brake trying to keep it cooler. No boost/stock config. 5% drag brake.
I dont know whats up???
Help if you can.
JT
Hi JT,
Give these settings a try.
Profile#2
Brake strength 80%
Brake PWM freq 8000HZ
Brake curve linear
Neutral drag brake 10%
Throttle PWM freq 9600Hz
Throttle punch 15%-20%
Throttle curve linear
Deadband middle
no timing- default
no motor protection
esc protection 240 degrees
