R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 08-14-2011 | 04:00 PM
  #5105  
Ryno B4.1
Registered User
iTrader: (4)
 
Joined: Feb 2011
Posts: 411
From: Mesa, AZ
Default
Originally Posted by burris7555
I did the same today on my B4.1 and my 22. Worked out pretty good. I just cut the nipple off the wing mount, ground it half way smooth with a dremel and cleaned it up with a nail file then drilled it. All I had on hand as far as 3mm hardware and a counter sunk washer was the Lunsford Fat Boy motor screws but plan on using these screws below.

Picture below is my 22 so don't hate...

http://www.amainhobbies.com/product_...Mount-Screws-2



That looks really sharp. Nice work, thanks for the photo and the link to your preferred hardware. Why do you have a 4.1 and a 22?
Ryno B4.1 is offline  
Reply