Originally Posted by
MarqueeRc
Well, I just got back from home depot and purchased a similar looking puncher (only its red)
...I tried it a few times on other tires..It works good, but when i punched a tire mounted on a wheel, it does go through the foam??Will this alter the integrity of the foams? The hole goes through the foam small and precise..Will this caus any issues??If i have the wheel off the tire it is a clean cut through the tire and does not effect the foam..The tire i need to punch are mounted?? I know i can make an incision of ther bead but would rather not..Will the foams be ok?
What tire and foam was it? I punched some holes in jconcepts subcultures and proline calibers that i got pre mounted and i didnt pull out any foam with the tire rubber. I would imagine that that tiny amount of foam probably wouldn't hurt performance anyway.