Okay. What in the %&#! is the deal. I have read over this forum, done the Spacer idea. Ran a 540 can motor... Ugh. Lemme just list this.

540 1410 Castle
- THREE Washer spacers, barely got up and went, screamed like a dying animal till the disks warmed up and still wasn't 'great'.
- 540 works *GREAT* in my Slash 4x4

550 1415 Castle
- bought a brand new Slipper system. Thrust bearing, washers, spring, cap, nut. etc. tightened everything up, slowly all.... the... way... down to a completely compressed spring and STILL absolutely no acceleration.
- 550 works *GREAT* in my Slash 4x4.

I've tested the motors and ESC possible suggestions by switching vehicles. *It is not the motor or ESC*

This thing spins for TEN PLUS FEET before it will go. I've fought with this for months. And honestly, i'm getting very tired of it. I understand this stupid basket thing solves that, but I find that rediculous honestly. (no offense)

Is there anything i'm missing? Brand new pads, I chopped and roughed up. new disks, scratched those up now too out of desperation. Motor is iiiiiice cold, Slipper disk is on fire.