Originally Posted by
tcb22185
Not sure where you get 2 2mm spacers i have the lipo top deck so i think i only need 1 2mm spacer. plus im running the exotek chassis and its 2.0mm thick! so im loosing some there too.
If you are using this
http://www.hotbodiesonline.com/showi.../67695_002.jpg
With the 2mm spacer you see in this picture on the chassis, you also need two 2mm spacers under the rear top plate
I know two guys that thought they had the BL motor mount only to find out after looking at my Cyclone they had the stock mount.
When I was using the stock motor mount the 109 spur stuck out under the chassis.
Originally Posted by
idbdoug
Are most Cyclone TC racers using the stock front and rear arms or are you using arms from Pro4???
Thanks
idbdoug
I'm also using the pro4 arms, as stated they seem to last longer then the TC arms.