R/C Tech Forums - View Single Post - Alex Racing Barracuda R2 & R3
Thread
:
Alex Racing Barracuda R2 & R3
View Single Post
06-21-2004, 03:40 PM
#
11425
JDM_DOHC_SiR
Tech Champion
iTrader: (
31
)
Join Date: Aug 2002
Location: Chula Vista, CA
Posts: 9,087
Trader Rating
: 31 (100%
+
)
Quote:
Originally posted by Merciless
Are any of you guys trying to get the corner weights correct ??
I.E 25% of the total weight on each wheel
Or are you just "leveling" it with the shocks ?? like taking out the tweak ??
I'm having a very hard time trying to get the corner weight equal alround and i've even put 1 of the cells on the same side as the motor to help
My next idea was to get the chassis under the servo cut out so i could put lead weight under the servo to help out as it's deffinately at the front on the servo side where the chassis light !!
Getting the two sides of the car even is easy but trying to get all four corners the same is proving near impossible
To be honest it ain't even close
I think that youmight be trying to hard to get it perfect
just worry about left and right balance and then tune the car for over and under steer from there
but you are on the right direction with the weight on the motor side and the servo area too
take a look at some of thhe pis I will attach and you will see a few good ideas
-Dave
Attached Thumbnails
Reply
JDM_DOHC_SiR
View Public Profile
Find More Posts by JDM_DOHC_SiR
View iTrader Profile