R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 07-31-2011 | 05:22 PM
  #5527  
Jstall7543's Avatar
Jstall7543
Tech Elite
iTrader: (2)
 
Joined: Jul 2009
Posts: 3,106
From: Down Town Olympia
Default
Originally Posted by macke
Slipping slipping slipping... Even with the HT pads. They get glazed after a few packs. Can't tighten the slipper spring nut fully, the top shaft starts to bend... How hard can it be to manufacture a spring that compresses evenly? Why can't AE come with a solution to this? They must have seen this slipping problem during the test phase...

I guess the only solution is to order the clutch basket. MTK, you're gonna get rich
It sounds like its not put together correctly. Maybe buy a new spring, you shouldn't need to have it all the way tight. Mine is like 2 turns tighter than what the book shows and will wheely sometimes on indoor clay with the 3800 4pole. Maybe you have a old kit with thin washers.
Jstall7543 is offline  
Reply