Originally Posted by
19quiz76
It seems like the servo from the Strike is too big to fit into the B44 - do I need a new one?
Could anyone recommend a budget solution, I don't want to put too much $ into this until I know for sure I want to stick to 1/10, and not give into the urge to go 1/8..
Also - it doesn't seem to be a designated space for the rx and esc, where did you guys place them and how did you fasten them?
Savox works for me and they are cheaper but great quality. Receiver goes on the right side opposite the servo and the ESC right next to the servo on the same side as the servo. Both attached via good double sided tape.