I did ensure that the sensor wire was fully in both my tc spec v2. and motor. I just replaced the motor with the same motor and am still having the same problem. Im going to try replacing my sensor wire and go from there. All my solder connections look good. And my bullet connectors are in my battery firmly. I did loosen my belt a tad to reduce drag but problem is still there, it slmost sounds like my belt is skipping but its the motor. Maybe i will try loosening my slipper a bit to let it slip and the motor spool up.
Getting a little upset, kinda wishing i didnt start wondering away from my usual two classes, 2wd buggy and 4wd buggy
Hey man, check the instructions on both your speedo and motor and make sire the wires are going to The right places. I've NEVER had a cogging problem with an lrp motor or escape and they are all that I use.