R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 07-25-2011 | 01:13 PM
  #5171  
lodhammerdin's Avatar
lodhammerdin
Tech Master
iTrader: (77)
 
Joined: Jun 2010
Posts: 1,194
From: Northern Mexico (aka, El Paso, TX)
Default
Originally Posted by 1Fastpede
lrp's seem to run hot naturally. i would say go to 12 but i bet it wont help. what speedo? any timing? as someone else mentioned my wheel hexes where rubbing the bearings. causing drag. also make sure you temp your slipper when your done! if its ridiculously hot then your slipping so much your motor is not happy.
What would you say is a good temp for the slipper to be after a five minute heat and a 10 minute main? Thanks for your input.
lodhammerdin is offline  
Reply