R/C Tech Forums - View Single Post - Ofna Ultra GTP2e
Thread
:
Ofna Ultra GTP2e
View Single Post
07-23-2011, 07:45 PM
#
939
Capt'N_Slow
Tech Regular
iTrader: (
10
)
Join Date: Aug 2008
Location: Calgary
Posts: 454
Trader Rating
: 10 (100%
+
)
Has anybody had there pinion run off the end of there motor shaft. Will put thread lock on the set screw tomarrow but was curios if this is what most are doing.
Running 1900kv 4s with 23/47 gearing. Mid 50mph at the top end.
Reply
Capt'N_Slow
View Public Profile
Find More Posts by Capt'N_Slow
View iTrader Profile