R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 07-22-2011 | 08:36 AM
  #5015  
CraigMBA's Avatar
CraigMBA
Tech Elite
iTrader: (22)
 
Joined: Mar 2003
Posts: 2,838
From: Valley of the Dirt, CA
Default
Originally Posted by GuiltyByAssoc
^^ Still early on my build, I think I've got the same problem with the tranny. When I turn/spin the shaft by itself after about 4-5 turns it gets really tight then it'll lossen up, after a few turns its tight again...repeat. But when the tranny box is open all the gears turn freely?
Totally normal. Run a couple of packs through it and bed in the gearboxes and recheck, but my front one did exactly this and cleared up after I ran it.
CraigMBA is offline  
Reply