Originally Posted by
chicky03
I have never put the serpent tubes on the on point chassis so the side to side movement I am not sure will let the pod move side to side. You may need to trim them if the pod side movement is not far enough. For shimming the ball studs 2-3mm on top of the cross brace and under the top deck should do it.
Back from a race meet, I finished 4th overall. The tubes fit with no problems and seemed like the side to side movement was not hindered by the tubes. (Only measure with eye, by comparing them off and on). Car was very easy to drive, almost too easy and lacked a little bit of turn in. This was with the on point conversion and serpent tubes.