R/C Tech Forums - View Single Post - TC4 Brushless conversion
Thread
:
TC4 Brushless conversion
View Single Post
07-20-2011, 10:46 PM
#
43
rc18junky
Tech Apprentice
Join Date: May 2010
Posts: 82
Trader Rating
: 0
it will work unmodded but if you want it to work perfect. if you look at the cv you will see a rub mark from before i cut them .that how much i took off a little over 5mm
Last edited by rc18junky; 07-20-2011 at
11:11 PM
.
Reply
rc18junky
View Public Profile
Find More Posts by rc18junky
View iTrader Profile