Originally Posted by
Kregger
Is anybody out there runnig a TA-05 with the original suspension. If so I was wondering what your solution was to the ball cup rubbing on the inside of the front rims. Right now I'm using the 6 mm hexes but I really don't care for the way the car is turning in. I was thinking about shortening the toe blocks.
I have had this same problem and with the TA-05 kit I have, it used the TA-04 front C hubs. I added a set of ball studs into the inner set of holes on the hub and did the same on the bulkhead. It seemed to keep the geometry about the same, and I just cut the head off of the kingpin stud. Hope this helps.