Originally Posted by
Verndog
Actually not. There is a wider gap from the 0 to the 1 then the other blocks. The 0-1 is more like 1.27mm and the others are closer to .76mm.
Here is a PDF of the exact numbers. B0 to A3 is .53mm.
http://www.ppdbillet.com/TC6-Block-Heights.pdf
I stand Corrected, that's what I get for listening to Ron Atomic :P
Yes, the biggest difference is between 0 and 1 blocks. I come up with 1.3mm which is consistent with Verndog's numbers, However, B0 to A3 I come up with roughly 0.8mm on 3 different cars. Ron was probably referring to the TC5 blocks, since the TC5 did not come with the 0 blocks. Makes sense though,This is where the 0's come in, to bridge that gap and make all the blocks and positions about essentially 1mm (0.8 for most and 1.3 for the above mentioned 0-1 difference.)