Originally Posted by
Numburn
Those that have installed the clutch basket...
How are you modifying the cover? I tried heating it up and molding over a motor, but could not get the thing to mold. It did start to melt the inner ring the rubber cover goes on though. Does anyone have pictures or suggestions? I was thinking about just adding 1mm where between the cover and housing.
I know not everyone has big sockets in their tool box but...
I took a 1 1/2 socket on the outside of the cover a 1 1/8 on the inside of the cover and ran a long bolt/nut through the the sockets and the center slipper adjusting hole in the cover. I tighten the bolt and it pushes the little socket in to the big one coning the cover out. Put some heat too it with my wifes super hair dryer and then let it cool. Makes a perfect round bulge in the cover for the basket to clear.