I need a little setup help. I have been struggling with clearing a jump section at our track and I am not sure what to do... I need more distance by a foot or two... This is just our club track so not a ton of people to reference at the track and the ones that are clearing it are using a 22.

This is 17.5 with open speedo so I cannot just throw a bigger motor at it

front
1-O
1-A with 2 washers
0 toe
-1 camber
axle middle
30 degree caster
2 bump steer

Rear
1-I
1-B with 1 washer using C hubs and ground down ubrace
-1 camber
medium wheel base
3.5 degree toe
2 anti squat

I have 25mm ride height all around and a 6" wing with 5mm lip
brown springs front #1 piston 30 weight oil with 3 limiters
Kyosho dark yellow rear #2 piston 27.5 weight with 2 limiters