Originally Posted by
Matt @ Pro-Line
Since the bearings are the issue, you can just use the stock SC10 wheel bearings to solve the issue. We also might look at offering the boca bearings separately and discounted for those who had an issue but that hasn't been decided on yet.
Originally Posted by
Odin544
The fit is exactly the same even after swapping in the factory bearings. Any chance the axle is undersized?
ive contacted u and proline CS about this, CS said they have no current solution. i measured with my calipers and the axle is undersized, infact i had/have pictures showing the axle where you can see wear marks indicating the axle is spinning inside the bearing bore. stop saying its the bearing, yes the proline bearings were crap, and the AE bearings are better. BUT, i swapped bearings, the slop wasnt as bad, but was definately there. and yes the bearings/axles are shimmed properly. the AXLES ARE THE PROBLEM!