HW 120A V2.1 & HW 13.5T motor settings
Hi Guys, i have just purchased a HW motor to go with my HW ESC and was wandering what settings to use as my car is lacking top end speed at my local track. it has a 70m straight. I was running a novak ballistic until it cooked ( 2 runs @ 70'c, then 3rd came off at 110'C ) and it was lacking in brakes too :-(
these were my settings:-
7.4 FDR
1. Running Mode -For/Brake
2. Drag Brake -0%
3. Volt Prot -3.0v/cell
4. DRRS Punch Level -9
5. Brake Force -100%
6. Reverse Force -100%
7. Initial Brake -40%
8. Neutral Range -6%
9. Boost Timing -40
10. Turbo Slope -fastest
11. Overheat -Enable
12. Turbo Timing -24
13. Start RPM -8000
14. Turbo Delay - none
15. Timing ACC -250