View Single Post
Old 06-30-2011, 06:43 AM
  #9  
fix218
Tech Fanatic
iTrader: (103)
 
fix218's Avatar
 
Join Date: Feb 2009
Location: Griffin, GA USA
Posts: 850
Trader Rating: 103 (100%+)
Default

Originally Posted by curacing2 View Post
A problem i see with some starterboxes engagement point when you press down on the lid is the wheel doesn't spin up before the flywheel hits it or its just starting to roll on contact with the flywheel, and this is especially bad on a very tight motor...the starter wheel stalls under load from the tight motor but the batteries keep feeding the power making all the electrics get hot.

I found my new GO starterbox had an adjustment for this and its made a big difference hitting the wheel when its spinning at full rpms.
+1 you have to let the bump box motor rpm's top out... the other thing is run Deans or some other high current plug... I am running a 25c 4S lipo in my ofna truggy box for over a year now... If you are running the stock plug like a Tamiya type IT WILL MELT>>>

here is mine
fix218 is offline  
Reply With Quote