hi guys, i'm building a T3R and have run into problems with the clearance of the steering servo.
im using a savox 1257 (normal profile) and it requires appx 7mm of shims against the servo posts in order for the servo arm to clear the top deck for its entire range of motion.
can anyone advise if this is normal? or what I can do? i cant even use the 3x10mm screw because it isn't long enough.
THEN, i realized that since the servo is set so far back from the centerline, it doesn't give me enough clearance to mount the antenna base.
is the solution to just buy a low profile servo?