R/C Tech Forums - View Single Post - Hyper TT 4wd 1/10th Truggy Thread
Thread: Hyper TT 4wd 1/10th Truggy Thread
View Single Post
Old 06-27-2011, 12:58 PM
  #2974  
FangsCPO
Tech Master
 
FangsCPO's Avatar
 
Join Date: Jul 2010
Location: Chula Vista, CA
Posts: 1,096
Default
Originally Posted by teknic
I ran mine for the first time yesterday with the Tekin 4.5 (sensorless) and a 14t and it was much more than I needed for the track I was at.

I planned on going to the outdoor 1/8th scale track, but it was still pretty wet/muddy so I ended up going to the indoor track so I could run both my trucks a bit.

I'm having a problem where it seems like if I take a hard landing the electronics will shut off...not sure what's causing it though.

TT ran pretty well also with the VXL and 14t until I broke the rear upright on it.
You might have a bad on/off switch. YOu can either replace it or remove it all together. Are you using the RX8 or MMPro? I had issues with the MMPro so I went to the RX8 and no more problems.
FangsCPO is offline  
Reply