R/C Tech Forums - View Single Post - Tune With Camber Links
Thread: Tune With Camber Links
View Single Post
Old 06-25-2011 | 12:06 PM
  #189  
larlev's Avatar
larlev
Tech Master
iTrader: (4)
 
Joined: Apr 2011
Posts: 1,533
From: Austin, Tx.
Default
Originally Posted by Kash$
Ok thanks
3/64 is basically a 1.18mm bit or #56. Used this for the Losi scte. Dremel makes a nice little $8 kit that has all the smaller sizes.

I'm sure you found them by now..but thought I'd say that anyway.
larlev is offline  
Reply