Hey guys.

Just bought two Hi-Tec HS 645MG servos for my 1/8th scale buggy project. I also just got a new RC4WD transmitter and receiver, the Rock Crawler 2.4GHz 3-Channel and a y-harness so i can have 4 wheel steering (that's why i got two servos, duh).

My problem is that when i change the 3rd channel switch to allow for front wheel steering, rear wheel steering, crab walk, and four wheel steering, nothing happens for front wheel steering, and for the rest of the settings, the servos turn the same direction each time, instead of adjusting to what should be happening (i.e.: rear wheel steering, just one servo should be operating, same for crab walk and four wheel steering, they both turn, just in the same direction.) I know for crab walk this is correct, but why should that be the only one to work properly.

Any help would be greatly appreciated.