R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 06-21-2011 | 03:29 PM
  #3541  
JS's Avatar
JS
Tech Master
iTrader: (70)
 
Joined: Feb 2009
Posts: 1,139
Default
Originally Posted by Waldo183
For the people with the Tekno alum axle hexes where do you put the shims? In between the rear hub and the hex?
When I bought my Tekno Alu hex set - It did not have the shims.
I used these: Traxxas 6x9.5x0.5 - 3981
I put one in between the hex and the outer bearing (Outer bearing, Washer, Pin then Hex) on all 4 corners.
Be careful with the cap head screws - can get easily stripped.
I stripped one already - So I upgraded them whith these:
PROTEK Cap Head Screw M2x5mm – PTK-H-1002
Much stronger - A little bigger and snug fit - works great.
Last edited by JS; 06-21-2011 at 04:02 PM.
JS is offline  
Reply