Thx Fast,
but A) how can u even see if the PAD is in the HEX perfectly? Once the SPUR is on, u cannot see if it is in the HEX perfectly.
I read here that some ppl have grease the pad? Can I put a lil amount of grease to hold it in place?

Also, 2.90MM is the width correct? The full width or the width of the spacer not including the part that fits into the slot??(not sure what that lil section the fits in is called.)
I figure if i order more SLIPPER HARDWARE #91090, i could use a 2nd slipper washer, instead of just finding a washer that fits. I know the inside of the slipper thrust washer is 6mm, so if i have to I could find it.
THX