R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 06-18-2011 | 06:51 AM
  #3334  
symmetricon's Avatar
symmetricon
Tech Elite
iTrader: (27)
 
Joined: Jun 2009
Posts: 4,882
From: houston
Default

Originally Posted by Farmer_John
Ok, so after fussing around with this truck for a month(ish), It's starting to drive like it has a mind to be driven. After building Swaybar sets in varying thickness and shapes and mucking with camber length and roll center, I slapped a pair of double Ds (green) on the front and a set of HB beams (whatever their soft compound is) on the rear.

Started treating me like a girlfriend instead of the neighborhood bully...

Tight, well kept and ran moist indoor clay track.

Front:
Camber -2.5
3.5mm spacers under inner ball
30k dif
shock; middle/outer/40w ASC/no boots/no limiters/built emulsion
2.3mm sway
24mm ride height

Rear:
Camber -2/inner hole at hub
2mm spacers under inner ball
5k dif
shock; inner/outer/32.5 Losi/no boots/no limiters/rod end 3 turns out/built emulsion
2mm sway
24mm ride height

other:
19t front pulley
clicker locked
deglazed stock pads...
1410 at 13/62

Although it could still use a little off power steering, it has now stopped doing the Joey Chitwood every time it sees a turn...
hey farmer, check to see if your rear a arms hit the outdrives. When I switched to no boot, 3 turns out on the shocks rod ends, the shocks allow the a arm to compress and hit the outdrives. I had to add thse limiter clips in the rear
symmetricon is offline