R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 06-14-2011 | 10:27 AM
  #3209  
Cpt.America's Avatar
Cpt.America
Tech Lord
iTrader: (52)
 
Joined: Mar 2009
Posts: 11,085
From: Washington State
Default
Originally Posted by gguertin145
Thanks!

I would love to hear what you think.

IMO without knowing the exact production reasons the older u brace was lower .
The Ubrace wasn't lower. This is a modifcation so that the angle and length of the upper camber link stays the same, when changing to the graphite ball stud mounts, over the hubs. Because the graphite ones are 2mm shorter, you need to lower the inner ballstud location by 2mm to match. Which is why they recommend grinding it down.

somebody tell me if i have this completely wrong please
Cpt.America is offline  
Reply