Originally Posted by
TommyBlazin
thats a 2mm shim under the rear outside hubs, where the upper camber link attaches to, place a 2mm under there? also on the front droop is it 0 or 2? please confirm, thanks
You can refer to the updated setup sheet for details, I corrected that sheet as stated in my quoted post so that should be good to use for all of the settings.
The setup sheet is not any different than any others in its function. They do not change the graphics as the entered data is changed. The image of the droop gauge will always show zero, but it is only the entered numbers that are important.
- Bryan